Piece a super cub together

[inline300]

I have a 4ch tx and 6ch receiver and a 3s 1300mah 15c lipo with four servos.

I was thinking about getting individual parts and put a super cub together.

Id like to make this a low buck deal.

Maybe someone that has been there done that could recommend a parts source and a motor/esc/prop combo.

I have a brushless esc but its mysteriously lost a component:
i3.photobucket.com/albums/y97/inline300/whatisthis.jpg

maybe I could repair that and run a brushless.

Any ideas appreciated, just think LOW BUCK.

I was thinking about not running rudder but going with ailerons and elevator only.

I also have a 3700kv inrunner motor but I have no clue what prop/esc would be needed...think im limited to a small prop anyway.


Thanks

[alexinflight]

I will respond tonight when I have more time. I parts built a SC for a friends...details soon.

Sorry, I have been sooo busy.

Alex

[ginginho]

It sounds like Alex is the man with all the info on this, but the piece that the arrow points to is a capacitor (black tubular looking item). You should be able to get a replacement from an electrical store, I would suspect that the lost one would have the same as the one that remains so you should be able to work out what rating is required for a replacement.

[alexinflight]

Here is where I bought all my parts to build a Super Cub:

secure.hobbyzone.com/catalog/HZ/hobbyzone_supercub/hobbyzone_supercub_parts/

I had a spare 72 mhz RX and TX , I just needed all the foam parts.

[inline300]

Thanks.

I finally decided to just make one from depron.

If anyone has the dimesinos on the supercub, I started a thread huntin for that info. thanks