Post by primetime34 on Mar 30, 2008 3:08:47 GMT 1
Well, we have three different super cubs (channels 1, 2, and 6) and we've crashed them a few times but we are actually pretty good with them now. We have already done the lipo upgrade and deans ultra ends. With that being said, we have an issue:
After a nose-dive, each of the planes ceased working. The electronics on the board work fine, but the rx/esc is not receiving a signal. It could be an issue with the crystal, but I don't know.
It has happened with all three planes.
They are into to Horizon for warranty repair right now. So, here's the question:
Should I think of upgrading the electronics in the three planes?
I don't want to buy new tx if I can avoid it.
What cost am I looking at to upgrade the rx, servos, and esc? Remember this would be for three planes...can we do it for less that $100 total for all three planes? Thanks.
After a nose-dive, each of the planes ceased working. The electronics on the board work fine, but the rx/esc is not receiving a signal. It could be an issue with the crystal, but I don't know.
It has happened with all three planes.
They are into to Horizon for warranty repair right now. So, here's the question:
Should I think of upgrading the electronics in the three planes?
I don't want to buy new tx if I can avoid it.
What cost am I looking at to upgrade the rx, servos, and esc? Remember this would be for three planes...can we do it for less that $100 total for all three planes? Thanks.