Post by flyinghigh on Mar 15, 2008 22:52:37 GMT 1
I'm trying to set up my dx6 and AR6000 to work in my cub. I've run into a few problems and have a few questions.
First, why does it take so long for the RX to start up? From the time I plug in the battery to the time the RX orange light comes on is like 30 seconds.
Next, I'm installing ailerons on my cub too. I've got everything ready to fly. When I make the ailerons work, one goes down about 1/2'', while the other only goes up about 1/4''. How do I get them to throw the same amount?
Lastly, the servos are not smooth at all. When operating the controlls, everything seems jerky and not very proportional. It almost seems as if there is interference. Could this be a servo problem? All of the servos act this way. I'm using HXT900's.
Thanks.
EDIT: Ok, I tried it again, and this time, the RX connected in like 10 seconds like normal. Also, the jitterness of the servos is gone and it seems to be working ok. Huh, weird.
The Aileron throw question still stands.
First, why does it take so long for the RX to start up? From the time I plug in the battery to the time the RX orange light comes on is like 30 seconds.
Next, I'm installing ailerons on my cub too. I've got everything ready to fly. When I make the ailerons work, one goes down about 1/2'', while the other only goes up about 1/4''. How do I get them to throw the same amount?
Lastly, the servos are not smooth at all. When operating the controlls, everything seems jerky and not very proportional. It almost seems as if there is interference. Could this be a servo problem? All of the servos act this way. I'm using HXT900's.
Thanks.
EDIT: Ok, I tried it again, and this time, the RX connected in like 10 seconds like normal. Also, the jitterness of the servos is gone and it seems to be working ok. Huh, weird.
The Aileron throw question still stands.
