coreyg
Flight lieutenant
Posts: 36
|
Post by coreyg on Apr 23, 2012 20:00:40 GMT 1
Hi. Din't know where to put this but, I need help with my servo arms. I got new servo's from the hobbyshop and they said that the 6.1 will fit in the super cub that I have instead of the 6.0. I think those are the right numbers that he said. The only difference is that the wires are longer. But, in truth, the servo arms are longer too and don't fit. Where can I get these servo arms? The wires don't bother me as I can tie them up and put them out of the way. But finding the right servo arms are the problem.
Any help is appreciated.
|
|
|
|
Post by toff on Apr 23, 2012 20:11:29 GMT 1
Corey, in what way don't they fit? If the arms are too long, just take a knife to them an cut down to the right size. If they don't fit the star shaped pin on the top (Too big or too small), get back to your LHS - take the original servo you're trying to replace if you can, and get a swap/ refund.
If you are doing a complete swap out of the electrics, most people use towerpro SG90's or Hi-tec HS81's. Just about any 9 gram micro servo will do, but those two are probably the most used.
|
|
coreyg
Flight lieutenant
Posts: 36
|
Post by coreyg on Apr 24, 2012 2:50:33 GMT 1
Sorry, I put Servo Arms, when it's actually the white piece that connects the servo to the servo arm. I think that's called the servo horn? Not sure.
But as luck would have it, I crashed my first last year and it caught on fire and had to get a new one. Lucky for me, I kept everything but the receiver and the too-hot-to-touch motor. I found it on my deck and looked in there, and found the pieces that I needed. YAY!
|
|
|
|
Post by realbob on Apr 24, 2012 3:09:56 GMT 1
Hey toff....
About towerpro SG90's or Hi-tec HS81's, one is mini other micro, which one is ok or are they same size?
|
|
|
|
Post by flydiver on Apr 24, 2012 3:36:04 GMT 1
|
|
