|
|
Post by pauliepilot on Dec 16, 2011 12:33:07 GMT 1
Ok so i went out n bought a bnf mcpx hoverd around my front room...n thought i'll take it out to the field :-) my first fig 8s inpressed :-D and so happy...but not to sure about tro curves n stuff...tail dosnt hold sometimes n just spins?
And info or help would be great ;-) as i no one or two of us are heli flyers
|
|
|
|
Post by freediverga on Dec 16, 2011 18:39:19 GMT 1
That's coaxial Helio right? You need adjust trim so both motors are spinning the same speed. My TX had a separate knob to do just that not sure about your dx6.
|
|
|
|
Post by pauliepilot on Dec 18, 2011 10:44:19 GMT 1
No its single bladed...flybarless!
|
|
|
|
Post by pauliepilot on Dec 18, 2011 10:50:05 GMT 1
My little mcpx :-)  |
|
|
|
Post by freediverga on Dec 18, 2011 23:53:28 GMT 1
should be some way to setup a trim dial on that DX6 doesn't have dial on the right and left side? The tail rotor is either spinning to fast or to slow. You have to have it adjusted just right because it has to speed up and slow as you you increase the boost because it has to counter act the the increased torque of the main rotor. You have to be able to hookup the TX to your computer and assign one of the dials to do the trim. once you figure that out get the helio off teh ground 16-18 inches off the ground then adjust with the dial. At that height ground affect shouldn't affect the helio so you can get the trim setup
|
|
|
|
Post by freediverga on Dec 18, 2011 23:56:04 GMT 1
|
|
|
|
Post by pauliepilot on Dec 24, 2011 13:23:46 GMT 1
Thanks for ur help...iv found settings that calm the mcpx down n make it fly a little more like my blade450 :-)
Im on my way now doing fig8s with the mcpx..bought a few bits for it allready but least a crash with the mcpx costs £10 normaly its just links that pop off :-)
£40+ with the blade450 :-0
|
|
|
|
Post by pauliepilot on May 4, 2012 16:48:14 GMT 1
Update:
So i pulled the servo port off the main board of my poor mcpx :-(
So i sold it cheep n going to put the money towards a blade 130x......the mcpx has made a big diffrence in my flying :-)
Only last week i looped n rolled my blade 450 :-D cant wait for the 130x to be shiped :-))
|
|
