|
|
Post by folg357 on Aug 5, 2007 2:45:02 GMT 1
I have a faulty servo on my new supercub, it was replaced by Hobbyzone and I was told replacing it was "easy". I am having trouble just unhooking the electrical connector and have not even gotten to the physical removal of the servo itself. I'm new to all this and need some advice. Thanks  |
|
|
|
Post by davemac2 on Aug 5, 2007 5:10:47 GMT 1
the small white 5 pin connector on the end of the servo wires should just pull out of the receiver. Just grip it firmly at its edges and pull it out. Disconnect the motor from the receiver and pull the receiver out to make it easier to get to the servo connectors. HZ uses some white caulking type stuff almost like bathtub caulk to glue in the servos and other stuff. You should be able just to use a bit of force to slowly pull the bad servo out.
dave mc
|
|
|
|
Post by SCC on Aug 5, 2007 9:35:44 GMT 1
|
|
