Post by colvid on Dec 4, 2008 18:06:31 GMT 1
Just finished. Cut the center section of the wing out which now covers top area where the upper wing would normally go. Inserted 2 aluminum tubes into the wing halves with one slightly smaller diameter so as to slide into each other. The holes in the side of the fuselage were sloopy so I cut very thin aluminum plates for a tight fit. Eflite 450 brushless. Weight without battery is just under 22 oz. CG is fine.
It is cold and wet today; will try first good day.
(Flew in a drizzle last week two days with no wind and it was great and didn't seem to hurt the two cubs flown.)
farm4.static.flickr.com/3131/3081958377_bc45c0bc77_o.jpg
It is cold and wet today; will try first good day.
(Flew in a drizzle last week two days with no wind and it was great and didn't seem to hurt the two cubs flown.)
farm4.static.flickr.com/3131/3081958377_bc45c0bc77_o.jpg
