carl
Flying officer
Posts: 1
|
Post by carl on Oct 18, 2008 18:24:32 GMT 1
I keep getting random interference when flying with other cub users. Even though we are on different channels I get the odd random movement on the elevator and rudder.
Does any one else get this?
Is there a solution if its common ?
Cheers
Carl
|
|
|
|
Post by patmatgal on Oct 19, 2008 17:38:11 GMT 1
Yeah, I got the same problem. As I understand it 27 mhz is a dead end for the radio, it's got to accept some interference. My stock Cub is on ch 5 and and now and then the elevator or rudder will twitch. What concerned me most was once when I was getting ready for a pre flight check and the prop started spinning. Since then I've gotten a DX6 radio and pretty much built a new Cub. Now I'm just a littls moe cautious with the stock Super Cub, but it's still fun to fly around.
|
|
|
|
Post by retiredbri on Oct 20, 2008 8:58:40 GMT 1
I think you need to ask some questions to get to the bottom of this problem.
1 Do other users on the field get similar problems to you?
2 Do ALL your problems go away when the other users switch off their TXs?
3 Do the problems happen when you are not at the field?
4 Do the problems change if you are not running the motor ie just sitting on the ground with the model secured, with your TX on and with the plane batteries connected?
4 As question 4 above, AGAIN WITH THE PLANE SECURE AND HANDS AWAY FROM THE PROP BUT with your TX off?
5 Do the problems change if you are on the ground and just run the motor at different speeds?
If you can get the answers, it may be possible to get to the root of the problem (and hopefully, solve it)
Regards, Retiredbri
|
|
