|
|
Post by foam flyer on Sept 22, 2008 2:47:52 GMT 1
 Can someone tell me what the material used is to attach the servos with... in my Cub its a creamy colored rubber type material I think if i have to use any more glue on my new friend I'll have to change her name to Super Club.
|
|
|
|
Post by duck9191 on Sept 22, 2008 4:35:11 GMT 1
you can use epoxy, gorilla glue, foam safe ca, or silicon caulk as its more then likely what they used at the factory.
|
|
|
|
Post by flydiver on Sept 22, 2008 6:22:45 GMT 1
It's likely silicone caulk.
I agree with most of ducky's suggestion except CA. If you get CA near servos the d**n stuff leaches into everything. I don't recommend it. Ugly mess for repair or problems later.
My favorite is to wrap it in masking tape, then hot glue (low temp) into place. The stuff holds well but can be removed if necessary. Try that with some other glue applications.
fly
|
|
|
|
Post by duck9191 on Sept 22, 2008 7:29:14 GMT 1
ya should have said that, be very carefull with ca, that stuff is wicked.
|
|
Can someone tell me what the material used is to attach the servos with... in my Cub its a creamy colored rubber type material
