colvid
Flying officer
Posts: 12
|
Post by colvid on May 21, 2008 22:25:30 GMT 1
Is there a way to remove the brushed motor and add a brushless motor and use the existing receiver. Brushed motor has two wires and the brushless has three.
I installed an AR6000 receiver, Spektrum DX6 transmitter, E-Flite micro servos and had a lot of inconsistent communication between the receiver and the transmitter. (Used the binding part.)
Thanks
Larry
|
|
|
|
Post by duck9191 on May 22, 2008 7:07:27 GMT 1
you need to switch out the stock rx/esc combo for the ar6000 and a brushless speed control. you cant use a brushed speed controller with a brushless motor.
|
|
zeta30
Squadron leader
Posts: 162
|
Post by zeta30 on May 23, 2008 2:26:52 GMT 1
You can't use the stock RX with a DX6. You should have a better communication between RX and TX with your set up.
When you bound the RX to the TX did you use the Bind jumper on the battery terminal on the RX?
Make sure when you bind it you need to plug the battery in to the ESC before turning on your TX. Once the battery is plugged in, push the bind button on the bottom of the TX and turn the TX on with the bind button pushed.
The RX should blink a few times until it establishes communication with the TX. This sometimes takes 5-10 seconds.
|
|
