PKZ1519 Charger Board

[bigtone]

This is a idea of mine that will help you if you have two pkz1519 chargers. I got a clipboard that I used for paper and then took the clip part off. I the got this three port 12v car adapter (from target) and hot glued and screwed it to the board. I then took the chargers apart and put a bolt through one of the five holes in the back after a little reaming. I put a wad of hot glue on the bolt head to stop it from shorting with any metal side the charger. After doing both bolts, I lined them up and tapped the hole with a drill bit trough the clip board. I then hot glued the tip of the four charger post feet on the bottom after putting the charger back togther. I then put the bolt through the hole and pressed as I tighten the two bolts on each charger as the hot glue set. I then cut the rest of the bolt off on the bottom that was to long so, the charger board will sit flat. You can just plug it into the cig lighter and hit the on switch on the 12v car adapter and you chargering two batteries. ;D

Note! (Change fuse for adapter and car to 10v or higher, 5v will blow under load)


image.rcuniverse.com/forum/upfiles/280476/Ec87704.jpg


image.rcuniverse.com/forum/upfiles/280476/Rm37809.jpg


image.rcuniverse.com/forum/upfiles/280476/Io28849.jpg


image.rcuniverse.com/forum/upfiles/280476/Mg97633.jpg


image.rcuniverse.com/forum/upfiles/280476/Ep86322.jpg


image.rcuniverse.com/forum/upfiles/280476/Vm83712.jpg


image.rcuniverse.com/forum/upfiles/280476/Oq21626.jpg

[cjg]

I like this.


You could velcro the chargers to the board so you don't have to mod them with a screw. That way they could be removed as well.

Velcro - what a great invention!

[bigtone]

I did the velcro but, my two year old like the way it sounds when he rips it off.