gg1968
Flying officer
Posts: 1
|
Post by gg1968 on May 5, 2013 17:13:55 GMT 1
Having issues with a Mini Super Cub. I want to go with a brushless setup. i have a T2208 1200kv motor with an 18A ESC installed. Motor is attached to the stock firewall with the stock " downward to the right thrust angle". Ive attached a 50g 2Cell 800mah battery. The plane will not takeoff without severe torque roll. I tried from the ground ( plane turns hard right to the ground right away). Ive tried hand launching and I used 3/4 -full throttle with up elevator. The plane just did a few rolls and crashed to the ground. Any ideas? Im thoroughly confused!!! Thanks everyone.
|
|
|
Post by renard80 on May 5, 2013 18:38:55 GMT 1
Sorry I can't offer any solution to your problem. I wondered whether you might also wish to post on the dedicated Mini Cub forum, here: minisupercubclub.freeforums.org/That board isn't so well used as this one but you may receive advice from fellow Mini flyers. Good luck!
|
|