|
Post by gigemaggs99 on Jul 13, 2012 5:48:43 GMT 1
I'm going brushless using this motor Power Up 450 Sport Outrunner Brushless Motor
It looks like from the pictures that the metal nose cone tightens with a small set screw. Is this the finished nose cone look? Or do you purchase a larger plastic nose cone to fit over this and the prop?
|
|
|
Post by gagallagher04401 on Jul 13, 2012 11:55:52 GMT 1
Their is a hole in the cone on the end. No set screw. There is a piece that slips onto the shaft, when this piece gets tightend down it grips the shaft. Then the other black piece goes on over the shaft and first tapered black piece. then your prop, and then the cone end with the hole in it. Hold the prop with your hand stick something small enough through that hole and turn it clockwise and tighten it up, that is how your prop is held on that is all the pieve you need. Pretty siple you will figure it out.
|
|