|
|
Post by mike012321 on May 15, 2009 13:25:29 GMT 1
I think I saw somewhere that someone had used a switch to select a "Lipo" or "Nimh" setting for use with the Super Cub (based on idea that the LVC jumper is used to either make or break a circuit). Maybe a switch could be sited on fuselage side,etc.
Could this be done? What sort of switch would I need?
|
|
|
|
Post by gagallagher04401 on May 15, 2009 14:08:13 GMT 1
It could be done. But i am thinking it would take a slector type switch. (I would have to think about it a little more)
There is a write up on this though that some one did it, I cant remember where it is. (I think ampaviators.com) Some one else will have to chime in.
Sorry I was not much of a help.
George
|
|
|
|
Post by duck9191 on May 15, 2009 19:49:02 GMT 1
solder a wire to each pin, then put one wire to each contact. just make sure that there is no continuity between the contacts in one position, and that there is continuity in the other position.
|
|
|
|
Post by mike012321 on May 16, 2009 7:53:39 GMT 1
|
|
|
|
Post by gagallagher04401 on May 16, 2009 14:50:06 GMT 1
hate to say this once you start flyin the Lipo's you are not going to want to use the slow Nimhs batteries anymore, better off to sell the and buy a couple more lipo's  thats what I did. George |
|
|
|
Post by flydiver on May 16, 2009 16:46:12 GMT 1
Agree, don't even bother.
|
|
|
|
Post by mike012321 on May 18, 2009 7:15:40 GMT 1
Seems using Lipos is going to be fun..  |
|
thats what I did.
